How to use oscilloscope in pspice schematics

#How to use oscilloscope in pspice schematics how to#

This saves any setting you have manipulated while you were in the plot window instead of resetting each time you run your circuit. You can save plot settings by going to plot window in your simulation setting and checking the show last plot option, you can do this during creation or edit your simulation and do this at anytime. Choose a start frequency and an end frequency and the points/decade amount for the simulation. To create a simulation for an AC Sweep/Noise, select AC Sweep/Noise from the Analysis Types drop down menu.

Click the Create button to open the Simulation Settings dialog. To create an AC sweep simulation, open the New Simulation dialog and repeat the same steps we described to name and inherit profile settings. You can toggle the view between different schematic simulations by selecting a simulation from the drop-down menu in the simulation toolbar. To create an additional simulation, return to Capture and select PSpice > New Simulation Profile. Any probes you selected will appear in your plot window. Open this window to view your simulation. A new PSpice A/D window entry is added to your main tool bar. Or select PSpice > Run from the main PSpice menu. To run your simulation, press the play button that is located in the simulation toolbar. Next to the probes in the toolbar, you can click the V, I, or W icons that are enclosed in a white circle to view the voltage, current and power at a bias point displayed on your circuit. There are also advanced probes you can select such as Fourier, average, derivative and more. Voltage probes can be places on any node, current nodes must be placed on component pins, and power pins must be placed on a component. The probes enable you to measure voltage, current and power. Setting up a maximum step allows you to set a step size than is less than the default.ДЄfter you create your simulation, youВ can use the probes located in the simulation toolbar to choose the points you want to measure. The step size determines how many points are measured during your run time. The Simulation Settings dialog includes controls that enable you to set the run time for your circuit as well as the maximum step size. This is the only type of simulation that can be performed on digital designs. The results of the simulation are presented as if the circuit was tested using an oscilloscope. The simulation is created when you click the Create button.ДЄ transient simulation is a measurement of the circuit in the time domain. In this example, we are selecting вЂњnoneвЂќ from the Inherit From drop list to create a new simulation with default settings. The Inherit From drop list provides menu choices you can select to either create a new simulation from scratch or by copying a simulation profile from another project.

In this example, we are entering the name вЂњtransient.вЂќ This selection opens the New Simulation dialog where we enter a name for the new simulation. Or we can select PSpice > New Simulation Profile from the main menu. To begin, we will select the New Simulation Profile icon from the PSpice toolbar.

After you complete this demonstration you will be able to:

#How to use oscilloscope in pspice schematics how to#

This PSpice video demonstrates how to setup a PSpice simulation. Solution home General PSpice PSpice Tutorial 5: Setting up a Simulation Profile